Skip to main content
Edelbrock

Edelbrock 71383 Pro Flo XT Vortec EFI Intake Manifold Black

Part # EDL71383 Be the first to write a review

Compatible with Small Block Chevy Vortec or E-tec Cylinder Heads

Read More

Edelbrock 71383 Pro Flo XT Vortec EFI Intake Manifold Black

Not Available

Edelbrock part #71383 Pro-Flo XT intake manifold is for 1957-1986 SBC swapped with E-Tec/Vortec heads or 1996 and later Vortec Engines. The Pro-Flo XT intakes are engineered with a large plenum and long tapered runners to deliver maximum horsepower and broad torque throughout the rpm range (1500-7000 rpm). Pro-Flo XT EFI intakes accept Edelbrock Pro-Flo XT Throttle Bodies and Fuel Rails. This manifold offers a durable black power coated finish for long lasting protection and a distinctive look.
Brand Edelbrock
Emission Code3
Product TypeIntake Manifolds
UPC085347713837
Manufacturer Part Number71383
Part NumberEDL71383
3

This part is legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles and Racing Use Only Vehicles.

The following vehicles are considered Uncontrolled (Non-Emissions Controlled) Vehicles:

  • 1965 and older U.S. manufactured California Certified vehicles
  • 1967 and older U.S. manufactured Federally Certified vehicles
  • 1967 and older Foreign manufactured vehicle

The following vehicles are considered Racing Use Only Vehicles:

  • Racing Use Only Vehicles are vehicles that are used exclusively for competition and that are not registered and that may never be used on the street

WARNING: It is against the law to install this part on an Emissions Controlled Vehicle

The following vehicles are considered Emissions Controlled Vehicles:

  • 1966 and newer U.S. manufactured California Certified vehicles
  • 1968 and newer U.S. manufactured Federally Certified vehicles
  • 1968 and newer Foreign manufactured vehicle
Recommended gasket: Edelbrock #7235; Manifold Dimensions: A-9.00", B-8.20", C-14.80"; Compatible with Edelbrock #38693 90mm Pro-Flo XT Throttle body.; Machined for a Edelbrock #36019 LS1 style MAP sensor, which mounts directly on the manifold.; The Edelbrock #3627 Fuel rail kit including provisions for either Pico or standard height injectors is available separately.; The throttle body centerline is located 2.5" behind and 6.07" above the front edge of the front end seal surface.; Fits late model low profile water neck (such as TransDapt 9929 or GM 12342024 chrome thermostat housing); No provisions for exhaust heated chokes or EGR.; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; To ensure maximum performance and a proper seal, Edelbrock gaskets which are specifically designed and manufactured for use with Edelbrock parts must be used.

Have a question about this product?

    Load More
    Reviews

      Your Review

      *Free Shipping & Handling only offered to the contiguous US on orders over $149, excludes clearance parts and oversized packages.

      Some parts are not legal for use in California or other states with similar regulations.